Items:, Value:

Design Idea : Galactic Bracelet

Kits & Design Ideas > Design Idea : Galactic Bracelet

Galactic Bracelet : Instructions

Thread a crimp bead onto the end of the wire, followed by the toggle loop then thread the wire back through the crimp bead and push it close to the toggle. Squash the crimp bead to grip the wire (using flat/chain nosed or crimping pliers).

Thread on a 6mm cheerio, followed by an 8mm round, a 9mm cheerio then a galactic bead, making sure the short tail of wire also goes through the beads, to hide it.

Thread on a 9mm cheerio, an 8mm round, then a 9mm cheerio, then a galactic bead. Repeat this pattern a further 5 times.

Thread on a 9mm cheerio, an 8mm round then a 6mm cheerio, followed by a crimp bead.

Thread on the toggle bar then pass the wire back through the crimp bead and the last three beads, pulling it to take up any slack in the bracelet, but not so as to make it rigid. Squash the crimp bead as before and trim any excess wire.